Alcraft Egg Artistry

Home > Burs

Burrs and wheels on this page are designed for air tools
They may be used in Dremels by using a 1/16" collet #482

All prices on this page - - - Net

	699 Carbide $3.00 Filigree Cutting		216 Flying Saucer 4mm $9.35 (Good for quick lattice design)
	699L Carbide $3.45 Fine Filigree Cutting		mm4 Diamond Football 4mm $10.18 Etching & smoothing rough edges
	207 Diamond Wheel 3/16" $20.65 .5mm thin cut Solid Surface		mm6 Diamond Football 6mm $17.60 Etching & smoothing rough edges
	213 Diamond Wheel 3/16" $28.22 .5mm fine cut - 3 holes in surface		229 Cone End Diamond $10.18 Concave lines & smoothing rough edges
	214 Diamond Wheel 1/4" $20.65 Large Cut		230 Round End Taper Diamond $10.18 Sculpting & smoothing rough edges

Flying Saucer - For Quail or Duck

#215 $8.25

Flying Saucer -For Quail

#300 $19.49


311 Flying Saucer 4mm Makes small petal shapes Use #481 collet $22.76	312 Flying Saucer 6mm Makes medium petal shapes Use #481 collet $22.76	313 Flying Saucer 10mm Makes large petal shapes Use #481 collet $22.76	945 Sanding Point Excellent for making small hole when emptying egg shells Use #480 collet $3.50

307 Diamond Wheel 3/16" Small Wheel for Dremel Use #481 collet $21.74	308 Diamond Wheel 1/4" Medium wheel for Dremel Use #481 collet $21.74	309 Diamond Wheel 5/16" Large wheel for Dremel Use #481 collet $23.43	BH86 Diamond Edge Wheel 5/8" Good for straight cuts 15mm Use #481 collet $19.95

402 Mandrel
Use to hold cutting disk
Use #480 collet
$3.50

Collet for Dremel to fit various shafts
#480          for 1/8" shaft
#481         for 3/32" shaft
#482         for 1/16" shaft
#483D       for 1/32" shaft
$3.50 ea.

#15 Cut off wheel 5/8"
Good for straight cuts
Mounts on # 402 mandrel
25¢

Home